Installation and Service Manual
Table Of Contents
- Dell EMC PowerEdge T440
- Dell EMC PowerEdge T440 overview
- Documentation resources
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Optional front bezel
- System feet
- Caster wheels – optional
- System cover
- Air shroud
- Drives
- Removing a drive blank
- Installing a drive blank
- Removing a drive carrier
- Installing a drive carrier
- Removing the drive from the drive carrier
- Installing a drive into the drive carrier
- Removing a 2.5 inch drive from a 3.5 inch drive adapter
- Installing a 2.5 inch drive into a 3.5 inch drive adapter
- Removing a 3.5 inch drive adapter from a 3.5 inch drive carrier
- Installing a 3.5 inch drive adapter into the 3.5 inch drive carrier
- Optical drives and tape drives
- Cabled drives
- Drive backplane
- System memory
- Cooling fans
- Optional internal USB memory key
- Expansion card holder
- Expansion cards
- Optional IDSDM or vFlash card
- Processors and heat sinks
- Power supply units
- Power interposer board
- System battery
- Control panel assembly
- System board
- Trusted Platform Module
- Converting the system from tower mode to rack mode
- Updating BIOS
- Restoring the Service Tag using Easy Restore
- Using system diagnostics
- Jumpers and connectors
- Getting help
Figure 34. Installing the optical or tape drive blank
Next steps
1 Follow the procedure listed in After working inside your system.
2 If applicable, replace the front bezel.
Removing the optical drive cage or tape drive
Prerequisites
NOTE
: The procedure to remove the optical drive cage is identical to removing a tape drive.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 If installed, remove the front bezel.
Steps
1 Disconnect the power and data cable from the back of the drive.
NOTE
: Observe the routing of the power and data cable inside the chassis as you remove them from the system board
and the drive. You must route these cables properly when you replace them to prevent them from being pinched or
crimped.
2 To remove the drive, push the release latch to release the drive.
3 Slide the drive out of the drive bay.
4 If you are not immediately replacing the tape drive, install the blank.
NOTE
: Blanks must be installed on empty optical drive or tape drive slots to maintain FCC certication of the system.
The brackets also keep dust and dirt out of the system and aid in proper cooling and airow inside the system. Perform
the same steps to install blanks.
82 Installation and Service Manual
Installing and removing system components