Installation and Service Manual
Table Of Contents
- Dell EMC PowerEdge R750xs Installation and Service Manual
- Contents
- About this document
- PowerEdge R750xs system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Drive backplane cover
- Optional optical drive
- Air shroud
- Cooling fans
- Side wall brackets
- Intrusion switch module
- Optional serial COM port
- Drives
- Drive backplane
- Cable routing
- System memory
- Processor and heat sink module
- Expansion cards and expansion card risers
- Optional IDSDM module
- MicroSD card
- Optional BOSS S2 card
- PERC
- Rear drive module
- Optional OCP card
- System battery
- Optional internal USB card
- Power supply unit
- Power interposer board
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Figure 55. Cable routing - 8 x 2.5-inch SAS/SATA drive backplane to the front PERC with cable riser 1A and BOSS
S2 card
Table 18. Cable routing - 8 x 2.5-inch SAS/SATA drive backplane to the front PERC with cable riser 1A
and BOSS S2 card
From To
BP_PWR_1 (Power connector on backplane) SIG_PWR_1 (Power connector on the PIB)
CTRL_DST_PA1 (Signal connector on PERC) SL3_CPU1_PB2 (Signal connector on system board)
PWR_1 (Power connector on BOSS S2 card) BOSS_PWR (BOSS power connector on PIB)
RISER_PWR_1 (Power connector on the riser) SIG_PWR_0 (Power connector for cabled riser on system
board)
RISER_DST_PB2 (Signal connector on riser) SL6_CPU2_PB3 (Signal connector on system board)
RISER_DST_PA2 (Signal connector on riser) SL5_CPU2_PA3 (Signal connector on system board)
Signal connector on riser SL7_CPU1_PA4 (Signal connector on riser)
Signal connector on riser SL8_CPU1_PB4 (Signal connector on riser)
62 Installing and removing system components