Quick Start Guide
Table Of Contents
- Dell EMC PowerEdge R750xs Installation and Service Manual
- Contents
- About this document
- PowerEdge R750xs system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Drive backplane cover
- Optional optical drive
- Air shroud
- Cooling fans
- Side wall brackets
- Intrusion switch module
- Optional serial COM port
- Drives
- Drive backplane
- Cable routing
- System memory
- Processor and heat sink module
- Expansion cards and expansion card risers
- Optional IDSDM module
- MicroSD card
- Optional BOSS S2 card
- PERC
- Rear drive module
- Optional OCP card
- System battery
- Optional internal USB card
- Power supply unit
- Power interposer board
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Table 28. Expansion card riser configurations (continued)
Configuratio
ns
Expansion
card risers
PCIe Slots Controlling
processor
Height Length Slot width Power
NA NA NA NA NA NA
Config5. NA NA NA NA NA NA NA
NA NA NA NA NA NA
NOTE: Only one cable riser can be installed at a time in any given configuration.
NOTE: R1B is a SNAPI riser.
NOTE: Config 4 and 5 are no riser configuration.
Figure 78. Riser 1A
1. Slot 3
2. Slot 4
84
Installing and removing system components