User Manual

Setting Up the Monitor  │  31
• Use the button to select Disable and change the settings.
Repeat the above steps to change the HDMI format settings if necessary.
Connecting the DisplayPort (DP to DP) cable
NOTE: The default out of factory setting in the U3419W is DP1.2. If the
monitor fails to show any content after the DP cable is connected,
follow the procedures below to change the settings from DP1.2 to
DP1.1:
• Press second button next to the button to activate the OSD menu.
• Use the and buttons to highlight Input Source, then use the
button enter the submenu.
• Use the and buttons to highlight DP.
• Press and hold the button for approximately 10 seconds, and the DP
configuration message appears.