Owner's Manual

34 Command Line Interface Reference
3 DEP_SOFT_ERROR Some possible explanations are:
• You attempted to update to the same version of
the software.
• You tried to downgrade to a previous version of
the software.
To avoid receiving this error, provide the /f option.
4 DEP_HARD_ERROR The required prerequisite software was not found
on your system. The update was unsuccessful
because the server did not meet BIOS, driver, or
firmware prerequisites for the update to be
applied, or because no supported device was
found on the target system. DUP enforces this
check and blocks an update from being applied if
the prerequisite is not met, preventing the server
from reaching an invalid configuration state. The
prerequisite can be met by applying another DUP,
if available. In this case, the other package should
be applied before the current one so that both
updates can succeed. A DEP_HARD_ERROR
cannot be suppressed by using the /f switch.
5 QUAL_HARD_ERROR The DUP is not applicable. Some possible
explanations are:
• The operating system is not supported by the DUP.
• The system is not supported by the DUP.
• The DUP is not compatible with the devices
found in your system.
A QUAL_HARD_ERROR cannot be suppressed
by using the /f switch.
6 REBOOTING_SYSTEM The system is being rebooted.
Table 3-2. Exit Codes (continued)
Value Message Name Description