Owner's Manual

Linux Troubleshooting 47
Kernel source for the running
kernel is installed, but the
currently installed OpenIPMI
driver RPM was installed
without the kernel source for
the running kernel. In order
to install OpenIPMI driver
modules for the running kernel
that meet the minimum version
requirement, use DKMS (see man
page for dkms) to install and
build OpenIPMI driver modules
for the running kernel.
Use DKMS to install and build the
OpenIPMI driver modules required by
your running kernel.
For information on using DKMS,
see the man page for DKMS.
You must reboot the system for
the update to take effect.
If you shut down or power off the
system after performing an update, you
will lose the update.
After performing a BIOS update, do not
power off the system. Reboot the
system for the update to take effect.
An Update Package is already
running. Wait until it is
complete before proceeding
with another update.
You can run only one DUP at a time.
WARNING: DO NOT STOP THIS
PROCESS OR INSTALL OTHER DELL
PRODUCTS WHILE <BIOS|FRMW>
UPDATE IS IN PROGRESS. THESE
ACTIONS MAY CAUSE YOUR SYSTEM
TO BECOME UNSTABLE.
Do not interrupt DUP execution.
Cannot find utilities on the
system to execute package.
The package must have certain utilities
to execute.
Make sure the following
utilities are in the
path:<path>
The utilities named must be in the path
mentioned in the message.
File already exists. The package is attempting to overwrite
an existing file.
Table 6-1. Messages
Message Description/Solution