User's Manual

Message Description/Solution
This update package requires an
OpenIPMI driver.
Currently no OpenIPMI driver is
installed on the system.
The DUP you selected cannot be installed because you
do not have the OpenIPMI driver installed on the system.
In order to assist in the <update|
install>,
you can download and install a version
of the OpenIPMI driver that meets
the minimum version requirement from
dell.com/support/manuals. The minimum version
required is <version>.
Download and install the minimum required OpenIPMI
driver from dell.com/support/manuals.
This Update Package requires a newer
version of
the OpenIPMI driver than is currently
installed on the system, which is
version <version>.
The OpenIPMI driver that is currently installed on the
system does not meet the minimum version requirements
of the selected DUP.
Kernel source for the running kernel
is not installed,
and the currently installed OpenIPMI
driver RPM was installed without the
kernel source for the running kernel.
In order to install OpenIPMI driver
modules for the running kernel that
meet the minimum version requirement,
you must install kernel source for the
running kernel, and then use DKMS (see
man page for dkms) to install and
build OpenIPMI driver modules for the
running kernel. To install kernel
source for the running kernel, install
the <filename> RPM that is applicable
to the running kernel.
Install the kernel source for the running kernel, and then
use the Dynamic Kernel Module Support (DKMS)
framework to install and build the OpenIPMI driver
modules for the running kernel.
You must install the kernel source by installing the .rpm
file required by the kernel.
For information on using DKMS, see the man page for
DKMS from linux.dell.com/dkms/manpage.html.
You must reboot the system for the
update to take
effect.
If you shut down or power off the system after
performing an update, you will lose the update.
After performing a BIOS update, do not power off the
system. Reboot the system for the update to take effect.
An Update Package is already running.
Wait until
it is complete before proceeding with
another update.
You can run only one DUP at a time.
WARNING: DO NOT STOP THIS PROCESS OR
INSTALL OTHER
DELL PRODUCTS WHILE <BIOS|FRMW> UPDATE
IS IN PROGRESS. THESE ACTIONS MAY
CAUSE YOUR SYSTEM TO BECOME UNSTABLE.
Do not interrupt DUP execution.
Cannot find utilities on the system to
execute package.
The package must have certain utilities to execute.
Make sure the following utilities are
in the path:<path>
The utilities named must be in the path mentioned in the
message.
File already exists.
The package is attempting to overwrite an existing file.
34