Users Guide
Advanced Management 73
Single Card Settings
Dell MUMC can configure a remote Dell Network Management Card.
Proceed as follows:
1
Login with an administrator profile.
2
Select one card from the list.
3
From the Node List button , select
Set Login Parameters
, enter the card Login and Password.
The access status changes from Access Denied ( ) to Access OK ( ).
After a few seconds, the Node configuration panel is updated.
4
Click the Edit button , or load a previously saved configuration.
5
In the Network Settings Configuration dialog box, check the parameters you want to change and fill in
the new values (see Figure 55).
Figure 55. Network Section
6
Apply the changes.
NOTE: The parameters that have different values on the cards and on the configuration to apply have the sign.
7
Select the parameters you want to synchronize (with the check box).
8
Click
Synchronize.
Some advanced parameters details are not displayed in the
Network Settings Configuration dialog box
.
You need to change the advanced parameters details directly on one device and then synchronize the
configuration from this device to other devices.
0119_2-Dell MUMC UG.book Page 73 Saturday, November 2, 2013 4:59 PM