Users Guide

Advanced Management 72
6
Advanced Management
Nodes Settings
Single Node Configuration Display
Dell Multi-UPS Management Console (MUMC) can display the card/application configuration for other
nodes on the network. Proceed as follows:
1
From Management> Nodes Settings, select one node from the Node List page (see Figure 54).
2 After a few seconds, on the right hand, the Node configuration panel is updated.
3 If you wish to save a standard node configuration (for example to deploy to other similar nodes), use
the
Configurations > Export Configuration file to export this configuration to a file.
Figure 54. Nodes Settings View
0119_2-Dell MUMC UG.book Page 72 Saturday, November 2, 2013 4:59 PM