Users Guide

Redundancy 100
Redundancy Configuration
To configure redundancy:
1
Login with an administrator user profile.
2 Select two or more nodes.
3 Click Set composite device (see Figure 82).
Figure 82. Selecting Set Composite Device for Nodes
4 In the dialog box, specify a device name, redundancy mode, and level (see Figure 83):
•
Device Name : User name of the composite device
•
Redundancy Leve l: The minimal number of redundant UPSs powering your system. The default
value is 0.
NOTE: If you set this parameter to a higher level, you will receive the “Redundancy Lost” alarm.
Figure 83. Set Composite Device Dialog Box
0119_2-Dell MUMC UG.book Page 100 Saturday, November 2, 2013 4:59 PM