Support Manual

Dell OpenManage Essentials v1.2 – Device Support

Dell Force10

Dell Force10 devices get classified under All Devices -> Network Devices -> Switches in the tree on the

left side. User can click the discovered device to see all the inventoried tables as shown in the

following figure:

Figure 6: Dell Force10 Classification & Inventory

Supported Models

OpenManage Essentials currently supports following Dell Force10 devices:

Table 2: Minimum firmware version that supports the display of Service Tag of Dell Force10 devices

Dell Force10 Model Minimum Firmware Version

C-Series 8.4.2.7

E-Series (ExaScale) 8.4.1.5

E-Series (TeraScale) 8.4.2.7

S25, S50

8.4.2.7

S55

8.3.5.3

S60

8.3.3.8

S4810

8.3.12.0

M-Series 8.3.16.1

Z-Series 9.0.0.0

Note:

The “Device summary” and “Switch Device Information” tables will show the service tag in the

“Service Tag” column only if the Dell Force10 device is running with the supported firmware versions or

later. Refer Table 2 for firmware versions supporting service tag for corresponding Force10 models. If the

firmware version is earlier than the one stated, the “Service Tag” column will show “N/A.” Firmware

version can be located under the “Version” column of the “Firmware Information” table.