Release Notes

4 Release Notes
• ESXi reports an incorrect MAC address for PowerEdge M-Series modular
systems enabled with FlexAddress.
• The network connection to one of the 10G ports may drop.
• ESXi fails to reboot from the OpenManage BIOS setup page.
• Error messages related to SFCB are displayed on ESX Service Console.
• System hangs during reboot when ESX is deployed through PXE
environment.
• Symbolic link warning messages are displayed on ESX service console.
• If you make licensing changes using vSphere Client and then reboot ESXi,
the changes are lost.
• ESX 4.x stops responding with a Purple Screen on the Intel Xeon 3400
series processor-based systems.
• ESX 4.x fails to boot and may drop into the recovery shell when you
replace the storage controller or import foreign configuration.
• ESX installation on a Dell PowerEdge R815 system stops responding.
• iDRAC vKVM input devices fail to function on Dell PowerEdge R815
systems.
• VMware VMotion without Enhanced VMotion Compatibility (EVC)
enabled fails on AMD Opteron 61xx and 41xx series processors.
• ESX has performance issues because of interrupt request (IRQ) sharing.
• The Windows Server 2008 operating system cannot be automatically pre-
activated on VMs.
• One or more uplink adapters (physical network adapter) may stop
functioning on heavy network stress.
• ESX 4.0 Update 1 fails to start after the installation of QLogic CNA
drivers.
• The target name of iSCSI LUNs may not be displayed in VMware vSphere
Server/VI Client.
• Incorrect devices are classified under the Processor section in the Hardware
Status tab of the VMware vSphere Server.
• RAID 10 virtual disks are displayed as RAID 1 in VMware vSphere Server/
VI Client.
• In Critical Array, the sensor is not asserted in VMware vSphere Server/ VI
Client.