Release Notes

VMware ESXi displays USB NIC description incorrectly
Description: VMware ESXi displays the description of Dell iDRAC USB NIC incorrectly as
unknown unknown.
Applies to: ESXi 5.x
Solution: This issue can be ignored because there is no functionality loss.
SD Card status displays incorrectly
Description: The status of the SD card is incorrectly displayed as unknown on the Hardware
Status tab of the ESXi host installed on the SD card.
Applies to: ESXi 5.x
Solution: This issue can be ignored because there is no functionality loss.
Floppy drive connected through USB port display its
name incorrectly
Description: The floppy drive mapped to the ESXi host through iDRAC via virtual media is
incorrectly displayed as USB CD media, instead of USB Floppy Drive.
Applies to: ESXi 5.x
Solution: This issue can be ignored because there is no functionality loss.
Fault-tolerant Shared PERC 8 controller failover takes
time to reflect actual state
Description: On PowerEdge VRTX enclosures, when a failover occurs to the active controller of
a Fault Tolerant Shared PERC 8, the initial active (IO) path appears unresponsive for
a few minutes before its active status registers.
Applies to: ESXi 5.x
Solution: There is no functionality loss.
VM guest operating system missing error after adding a
new vSCSI controller
Description: A VM fails to boot with an error message Operating System missing when a
new vSCSI LSI Logic parallel controller is added.
Applies to: ESXi 5.x
17