Service Manual
Table Of Contents
- Dell™ Vostro™ 420/220/220s Service Manual
- Troubleshooting
- Working on Your Computer
- Computer Cover
- Bezel
- Chassis Support Bracket
- PCI and PCI Express Cards
- Drives
- I/O Panel
- Fan
- Processor Heat Sink/Fan Assembly
- Memory Module(s)
- Power Supply
- Coin-Cell Battery
- System Board
- Processor
- System Setup Program
- Contacting Dell
Bezel 51
Bezel
CAUTION: Before working inside your computer, read the safety information that
shipped with your computer. For additional safety best practices information, see
the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To guard against electrical shock, always unplug your computer from
the electrical outlet before removing the cover.
NOTICE: The procedure for removing and replacing the bezel is identical for the
Vostro 420, Vostro 220, and Vostro 220s computers; the illustrations provided are for
example only and may not represent your particular computer precisely.
Removing the Bezel
1
Follow the procedures in "Before Working on Your Computer" on page 35.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 47).
3
With the computer still on its side, gently lift the clips slightly upward to
release that edge of the bezel from the chassis.
4
Rotate the bezel away from the computer to release the hooks on the
opposite edge of the bezel from the chassis.