Service Manual
Table Of Contents
- Dell™ Vostro™ 420/220/220s Service Manual
- Troubleshooting
- Working on Your Computer
- Computer Cover
- Bezel
- Chassis Support Bracket
- PCI and PCI Express Cards
- Drives
- I/O Panel
- Fan
- Processor Heat Sink/Fan Assembly
- Memory Module(s)
- Power Supply
- Coin-Cell Battery
- System Board
- Processor
- System Setup Program
- Contacting Dell
78 Drives
b
For the Vostro 220s
, lift the release latch that secures both the optical
drive and the 3.5-inch device in their respective drive cages.
c
Remove the empty-bay cover from the bezel: From the inside of the
bezel, press the release latch on the cover, and lift the cover from the
bezel.
5
Remove the media card reader from its packaging.
6
For the Vostro 220s, install two screws on each side of the media card
reader.
7
Gently slide the device into the bay from the front of the computer.
8
For the Vostro 420 and Vostro 220:
a
Align the screw holes in the device with the screw hole and slot in the
drive cage.
b
Replace and tighten the two screws to secure the device in the drive
cage.
1 inside of bezel 2 release latch
3 cover for empty bay
1
3
2