Service Manual
Table Of Contents
- Dell™ Vostro™ 420/220/220s Service Manual
- Troubleshooting
- Working on Your Computer
- Computer Cover
- Bezel
- Chassis Support Bracket
- PCI and PCI Express Cards
- Drives
- I/O Panel
- Fan
- Processor Heat Sink/Fan Assembly
- Memory Module(s)
- Power Supply
- Coin-Cell Battery
- System Board
- Processor
- System Setup Program
- Contacting Dell
Drives 81
5
For the Vostro 420 and Vostro 220, remove the two screws securing the
optical drive to the drive cage.
6
Slide the optical drive out through the front of the computer.
7
If you are installing a replacement drive
, skip to step 5 in "Replacing or
Adding an Optical Drive" on page 82.
If you are removing this drive permanently and the drive bay is to remain
empty
, proceed to step 8.
8
Disconnect the data cable from the system board (see "System Board
Components" on page 40), and remove the cable from the computer.
9
For the Vostro 420 and Vostro 220, use two screws to attach a 5.25-inch
front-panel insert to the front of the empty bay.
1 screws (2) 2 screw holes (4)
3 optical drive 4 data cable
5 power cable
4
5
3
1
2