Service Manual
Table Of Contents
- Dell™ Vostro™ 420/220/220s Service Manual
- Troubleshooting
- Working on Your Computer
- Computer Cover
- Bezel
- Chassis Support Bracket
- PCI and PCI Express Cards
- Drives
- I/O Panel
- Fan
- Processor Heat Sink/Fan Assembly
- Memory Module(s)
- Power Supply
- Coin-Cell Battery
- System Board
- Processor
- System Setup Program
- Contacting Dell
I/O Panel 91
Vostro 220s
Replacing the I/O Panel
NOTICE: Take care not to damage the cable connectors and the cable routing
clip(s) (if present) when sliding the I/O panel into the computer.
1
Route the I/O panel cables into the chassis through the I/O panel opening,
and guide them through the various holes and bays.
2
Slide the I/O panel cables into the cable clip(s) (if present).
3
Replace and tighten the screw that secures the I/O panel.
4
Reconnect the cables to the system board (see "System Board
Components" on page 40).
1 front-panel opening 2 I/O panel and cables
3 screw
3
2
1