Service Manual
Table Of Contents
- Dell™ Vostro™ 420/220/220s Service Manual
- Troubleshooting
- Working on Your Computer
- Computer Cover
- Bezel
- Chassis Support Bracket
- PCI and PCI Express Cards
- Drives
- I/O Panel
- Fan
- Processor Heat Sink/Fan Assembly
- Memory Module(s)
- Power Supply
- Coin-Cell Battery
- System Board
- Processor
- System Setup Program
- Contacting Dell
Fan 93
Fan
CAUTION: Before working inside your computer, read the safety information that
shipped with your computer. For additional safety best practices information, see
the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To guard against likelihood of electric shock, laceration from moving
fan blades, or other unexpected injuries, always unplug your computer from the
electrical outlet before removing the cover.
NOTICE: The procedure for removing and replacing the chassis fan is identical
(except where noted0 for the Vostro 420, Vostro 220, and Vostro 220s computers; the
illustrations provided are for example only and may not represent your particular
computer precisely.
Removing the Chassis Fan
1
Follow the procedures in "Before Working on Your Computer" on page 35.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 47).
3
Disconnect the chassis fan cable from the system board.
4
While holding the chassis fan in place, remove the screw(s) that secure(s)
the fan to the chassis.
5
For the Vostro 220s, slide the fan toward the front of the computer to
disengage it from the chassis.
6
Ease the fan toward the center of the computer, and lift the fan out of the
chassis.