Users Guide

116 | The Basic User-Centric Networks Dell Networking W-Series ArubaOS 6.4.x| User Guide
Are you sure that you want to stop auto-provisioning and start full setup dialog? (yes/no):
yes
Reading configuration from factory-default.cfg
***************** Welcome to the Dell W-7210 setup dialog *****************
This dialog will help you to set the basic configuration for the switch.
These settings, except for the Country Code, can later be changed from the
Command Line Interface or Graphical User Interface.
Enter System name [Dell W-7210]:
Enter Switch Role (master|local|standalone) [master]:
Enter VLAN 1 interface IP address [172.16.0.254]: 10.79.100.109
Enter VLAN 1 interface subnet mask [255.255.255.0]:
Enter IP Default gateway [none]: 10.79.100.1
Enter Country code (ISO-3166), <ctrl-I> for supported list: US
You have chosen Country code US for United States (yes|no)?: yes
Enter Time Zone [PST-8:0]:
Enter Time in UTC [02:24:44]: 02:36:44
Enter Date (MM/DD/YYYY) [12/3/2012]:
Enter Password for admin login (up to 32 chars): ******
Re-type Password for admin login: ******
Enter Password for enable mode (up to 15 chars): ******
Re-type Password for enable mode: ******
Do you wish to shutdown all the ports (yes|no)? [no]:
If you accept the changes the switch will restart!
Type <ctrl-P> to go back and change answer for any question
Do you wish to accept the changes (yes|no)yes
Creating configuration... Done.
System will now restart!
Add Licenses to the New Controller
Use the license add command in the command-line interface or navigate to Configuration > Network >
Controller > License Management to add new or transferred licenses to the new controller.
Do not reboot the controller at the end of this step. Do not save the configuration or write it to memory. Reboot only
after the flash memory and the licenses have been restored.
(host) #license add <key>
Backup Newly Installed Licenses
Use the license export command in the command-line interface or click Export Database in the
Configuration > Network > Controller > License Management page of the WebUI to back up the newly
installed licenses to the backup license database.
Do not reboot the controller at the end of this step. Do not save the configuration or write it to memory. Reboot only
after the flash memory and the licenses have been restored.
(host) #license export <filename>
Import and Restore Flash Backup
Import and restore the backup flash file system from the original controller to the new controller,
Do not reboot the controller at the end of this step. Do not save the configuration or write it to memory. Reboot only
after the flash memory and the licenses have been restored.