Users Guide

125 | Control Plane Security Dell Networking W-Series ArubaOS 6.4.x| User Guide
7. Click Add.
In the CLI
To add an AP to the campus AP whitelist:
(host) #whitelist-db cpsec add mac-address <name>
ap-group <ap_group>
ap-name <ap_name>
description <description>
To add an AP to the remote AP whitelist:
(host)#whitelist-db rap add mac-address <mac-address>
ap-group <ap-group>
ap-name <ap-name>
description <description>
full-name <name>
remote-ip <inner-ip-adr>
Viewing APWhitelist Status
The WebUI displays either a status of the selected APwhitelist or a table of entries in the selected APwhitelist.
The status page displays the current status of the APwhitelist and for controllers in a master/local controller
topology, it displays the APwhitelist synchronization status between controllers. When the status of an entry
in the APwhitelist changes, the APwhitelist status is updated automatically. The table of entries page displays
the status of each APon the APwhitelist.
The Configuration > Wireless > AP Installation > Whitelist tab displays the status of the campus AP
whitelist by default. To view the status of remote AP whitelist, click the Remote AP link.
The following table describes the contents of the status page.
Status Entry Description
Campus AP whitelist status information
Control Plane Security Shows if the control plane security is enabled or disabled on the
controller. This status entry is also a link to the control plane security
configuration tab.
Total entries Number of entries in the campus APwhitelist.
Approved entries Number of entries in the campus AP whitelist that have been approved by
the controller.
Unapproved entries Number of entries in the campus APwhitelist that have not been
approved by the controller.
Certified entries Number of entries in the campus AP whitelist that have an approved
certificate from the controller.
Certified hold entries Number of entries in the campus AP whitelist that have been certified
with a factory certificate but request to be certified again. Such APs are
not approved as secure until you manually change the status and verify
that it is not compromised.
Table 21: Whitelist status information