Users Guide

167 | Network Configuration Parameters Dell Networking W-Series ArubaOS 6.4.x| User Guide
Creating a Named VLAN Using the CLI
Named VLAN should not be used with static IP addresses.
The following example creates named VLAN called mygroup that has assignment type even.
(host)(config) #vlan-name mygroup assignment even
Viewing and Adding VLAN IDs Using the CLI
The following example shows how to view VLAN IDs in a named VLAN:
(host)(config) #show vlan
The following example shows how to add existing VLAN IDs to a named VLAN:
(host)(config) #vlan-name mygroup
(host)(config) #vlan mygroup 2,4,12
To confirm the named VLAN mappings assignments, use the following command:
(host)(config) #show vlan mapping
Role Derivation for Named VLAN Pools
You can configure Named VLANs under user rule, server derivation, user derivation, and VSA in this release.
You cannot modify a VLAN name, so choose the name carefully.
Named VLANs (single VLAN IDs or multiple VLAN IDs) can only be assigned to tunnel mode VAP’s and wired
profiles. They can also be assigned to user roles, user rule derivation, server derivation, and VSA for tunnel and
bridge mode.
For tunnel mode, named VLANs that have the assignment type “hash” and “even” are supported.
For bridge mode only, named VLANs with the assignment type “hash” are supported. If a named VLAN with
“even” assignment is assigned to a user rule, user role, server derivation or VSA, than the “hash” assignment is
applied and the following error message displays:
"named VLAN assignment type EVEN not supported for bridge. Applying HASH algorithm to retrieve vlan-id"
L2 roaming is not supported with an even VLAN assignment.
In the CLI
To apply a named VLAN in a user rule, use the following CLI commands:
(host)(config) #aaa derivation-rules
(host)(config) #aaa derivation-rules user <string>
(host)(config) #aaa derivation-rules user test-user-rule
(host)(user-rule) #set vlan
To apply a named VLAN in a user role, use the following CLI commands:
(host)(config) #user-role test-vlan-name
(user)(config-role) #vlan test-vlan
To apply a named VLAN in server derivation, use the following CLI commands:
(host)(config) #aaa server-group test-vlan-server-group
(user)(Server Group "test-vlan-server-group") set vlan
For a named VLAN derivation using VSA, configure the RADIUS server using these values: