Users Guide

195 | Network Configuration Parameters Dell Networking W-Series ArubaOS 6.4.x| User Guide
Viewing Operational Status
To view the operational status of all the tunnel groups and their members, issue the following command:
(Controller-1) #show tunnel-group
The following is the sample output of the show tunnel-group command:
(Controller-1) #show tunnel-group
Tunnel-Group Table Entries
--------------------------
Tunnel Group Mode Tunnel Group Id Preemptive Failover Active Tunnel Id Tunnel Members
------------ ---- --------------- -------------------- ---------------- --------------
branch_1 L2 16385 enabled 1 10 11
Viewing Active and Member Tunnels
To view the active member tunnel and all the member tunnels of the respective tunnel-group, issue the
following command:
(Controller-1) #show datapath tunnel-group
Following is the sample output of the show datapath tunnel-group command:
(host) #show datapath tunnel-group
Datapath Tunnel-Group Table Entries
-----------------------------------
Tunnel-Group Active Tunnel Members
------------ ------------- -------------------
16385 10 10 11
Viewing the Standby Member Tunnels
To view the standby member tunnels of the tunnel-group, issue the following command:
(host) #show datapath tunnel
The following is sample output of the show datapath tunnel command:
(host) #show datapath tunnel
+----+------+-----------------------------------------------------+
|SUM/| | | |
|CPU | Addr | Description Value |
+----+------+-----------------------------------------------------+
| | | |
| G | [00] | Current Entries 10 |
| G | [02] | High Water Mark 10 |
| G | [03] | Maximum Entries 32768 |
| G | [04] | Total Entries 31 |
| G | [06] | Max link length 1 |
+----+------+-----------------------------------------------------+
Datapath Tunnel Table Entries
-----------------------------
Flags: E - Ether encap, I - Wi-Fi encap, R - Wired tunnel, F - IP fragment OK
W - WEP, K - TKIP, A - AESCCM, G - AESGCM, M - no mcast src filtering
S - Single encrypt, U - Untagged, X - Tunneled node, 1(cert-id) - 802.1X Term-PEAP
2(cert-id) - 802.1X Term-TLS, T - Trusted, L - No looping, d - Drop Bcast/Unknown Mcast,
D - Decrypt tunnel, a - Reduce ARP packets in the air, e - EAPOL only
C - Prohibit new calls, P - Permanent, m - Convert multicast
n - Convert RAs to unicast(VLAN Pooling/L3 Mobility enabled), s - Split tunnel
V - enforce user vlan(open clients only)
H - Standby (HA-Lite)