Users Guide

Platform Maximum number of DHCP Leases Supported
W-6000M3 512
W-3400 512
W-3600 512
W-7005 512
W-7010 1024
W-7030 2048
W-7210 5120
W-7220 10240
W-7240 15360
Configuring DHCPv6 Server
You must enable the global DHCPv6 knob for the DHCPv6 functionality to be operational. You can enable and
configure DHCPv6 server using the WebUI or CLI.
In the WebUI
1. Navigate to Configuration > Network > IP page and select the DHCP Server tab.
2. Select the IPv6 DHCP Server check box to enable DHCPv6 globally.
3. If there are addresses that should not be assigned in the subnetwork:
a. Under Excluded Address Range, click Add to create a list of IPv6 excluded address.
b. Enter the excluded IPv6 address range in IPv6 Excluded Range and click Done. The specified address
range gets added to the IPv6 Excluded Address list box. The starting IP address in the Exclude
Address Range should always contain a unique value, if the IP address is already present, then the
existing IP address is replaced with a new one, and a warning is displayed.
c. Click Apply.
4. Under Pool Configuration, click Add to create a new DHCP server pool or click Edit to modify an existing
DHCP server pool.
To enable the DHCPv6 Server functionality on an interface, select the IP Interfaces tab, edit the VLAN interface, and
select a DHCP pool from the drop-down list under the DHCP server section. Ensure that the IP version of the VLAN
interface is IPv6.
5. Select IP Version as IPv6 to create a DHCPv6 pool.
6. Enter a name in Pool Name to configure an IPv6 pool name.
7. Enter an IPv6 address in DNS Servers to configure an IPv6 DNS server.
To configure multiple DNS servers, enter the IPv6 addresses separated by space.
8. Enter a value in Domain Name to configure the domain name.
Dell Networking W-Series ArubaOS 6.4.x | User Guide IPv6 Support | 214