Users Guide

F - Device is requesting fast LACPDUs
A - Device is in active mode P - Device is in passive mode
Port Flags Pri AdminKey OperKey State Num Status
---- ----- ---- -------- -------- ----- ---- -------
FE 1/1 SA 1 0x1 0x1 0x45 0x2 DOWN
FE 1/2 SA 1 0x1 0x1 0x45 0x3 UP
In the WebUI
Access LACP from the Configuration >Network >Port tabs. Use the drop-down list to enter the LACP values.
l LACP Group— the link aggregation group (LAG) number; the range is 0 to 7.
l Mode— active negotiation state or not in an active negotiation state indicated by the passive option.
l Priority—the port priority value; the range is 1-65535 and the default is 255.
l Timeout— time out value for the LACP session. The long default is 90 seconds; the short default is 3
seconds.
For information on configuring LACP on W-AP220 Series and W-AP270 Series access points, see Link Aggregation
Support on W-AP220 Series and W-AP270 Series on page 618
LACP Sample Configuration
The following sample configuration is for FastEthernet (FE) port/slot 1/0, 1/1, and 1/2:
Dell Networking W-Series ArubaOS 6.4.x | User Guide Link Aggregation Control Protocol | 227