Users Guide

319 | BranchController Config for Controllers Dell Networking W-Series ArubaOS 6.4.x| User Guide
Parameter Description
Compression The Compression/Decompression Engine feature is enabled by default. However, the
packets are compressed only if the IP Payload Compression Protocol (IPComp) is suc-
cessfully negotiated via the Internet Key Exchange (IKE) protocol.
BW Management
Uplink
Select an interface uplink to which you will apply the bandwidth contract.
Service Type
Select one of the available service types for this bandwidth contract:
l None: The contract applies to all upstream or downstream traffic on the interface.
l Application: The contract applies to a specific application.
l Category: The contract applies to all applications within a category type.
l Exclude: If a bandwidth contract is applied to an entire interface or category of
applications, you can create a bandwidth contract that excludes a single application
or application category from that contract.
Bandwidth Contract
If you chose the None, Application or Category option in the Service Type field, select
the name of the bandwidth contract to be applied to the interface.
Application
If you chose the Application option in the Service Type field, select the application to
which the bandwidth policy will be applied.
Category
If you chose the Category option in the Service Type field, select the application cat-
egory to which the bandwidth contract is applied.
Bandwidth Direction
Apply the bandwidth contract to upstream or downstream traffic.
PAN Portal
Portal IP The IP address or fully qualified domain name (FQDN) of the portal.
Trusted Certificate Specify the name of the self-signed or external certification authority (CA) certificate to
establish an SSL connection to the portal.
User Name Username to authentiate to the Palo Alto Networks portal.
Password Password to authentiate to the Palo Alto Networks portal.
Table 66: Branch Config Group WAN Setting
Branch ConfigGroup Summary
The Summary tab on the Configuration>Branch>Smart Config page displays a summary of the branch
config group configuration created using the Smart Config WebUI, and a summary of the settings on a specific
branch controller.
To view a summary of the branch config group settings:
1. Navigate to Configuration>Branch>Smart Config>Summary.
2. Select the Profile Summary subtab.