Users Guide

343 | 802.1X Authentication Dell Networking W-Series ArubaOS 6.4.x| User Guide
In the WebUI
1. Navigate to Configuration > Security > Access Control > User Roles page. Click Add to create the
sysadmin role.
2. For Role Name, enter sysadmin.
3. Under Firewall Policies, click Add. In Choose from Configured Policies, select the predefined allowall policy.
Click Done.
4. Click Apply.
In the CLI
(host)(config) #user-role sysadmin
session-acl allowall
Creating a computer role
In the WebUI
1. Navigate to Configuration > Security > Access Control > User Roles page. Click Add to create the
computer role.
2. For Role Name, enter computer.
3. Under Firewall Policies, click Add. In Choose from Configured Policies, select the predefined allowall policy.
Click Done.
4. Click Apply.
In the CLI
Use the following command to create a computer role:
(host)(config) #user-role computer
session-acl allowall
Creating an Alias for the Internal Network
In the CLI
(host)(config) #netdestination “Internal Network”
network 10.0.0.0 255.0.0.0
network 172.16.0.0 255.255.0.0
Configuring the RADIUS Authentication Server
Configure the RADIUS server IAS1, with IP address 10.1.1.21 and shared key. The RADIUS server is configured
to sent an attribute called Class to the controller; the value of this attribute is set to either “student,” “faculty,”
or “sysadmin” to identify the user’s group. The controller uses the literal value of this attribute to determine the
role name.
On the controller, you add the configured server (IAS1) into a server group. For the server group, you configure
the server rule that allows the Class attribute returned by the server to set the user role.
In the WebUI
1. Navigate to the Configuration > Security > Authentication > Servers page.
2. In the Servers list, select Radius Server. In the RADIUS Server Instance list, enter IAS1 and click Add.
a. Select IAS1 to display configuration parameters for the RADIUS server.
b. For IP Address, enter 10.1.1.21.
c. For Key, enter |*a^t%183923!. (You must enter the key string twice.)
d. Click Apply.