Users Guide
Table Of Contents
- Installation Guide
- Installationsanleitung
- Inhalt
- Zu diesem Handbuch
- PowerConnect W-3000 Serie Controller
- Installieren des W-3000 Serie Controller
- Technische Daten, Sicherheit und Konformität
- Guide d’installation
- Table des matières
- À propos de ce guide
- À propos des contrôleurs Dell PowerConnect Série W-3000
- Installation du contrôleur Série W-3000
- Spécifications, sécurité et conformité
- Guía de instalación
- Contenido
- Acerca de esta guía
- Acerca de los controladores PowerConnect Serie W-3000
- Instalación de los controladores Serie W-3000
- Especificaciones, seguridad y cumplimiento
- Guia de instalação
- Índice
- Sobre este guia
- Sobre os Controladores Série W-3000 PowerConnect
- Instalação dos Controladores Série W-3000
- Especificações, segurança e conformidade
- Kurulum Kılavuzu
- İçindekiler
- Bu Kılavuz Hakkında
- PowerConnect W-3000 Serisi Denetleyiciler Hakkında
- W-3000 Serisi Denetleyiciler Kurulumu
- Spesifikasyonlar, Güvenlik ve Uygunluk
- 設置ガイド
- 설치 안내서
- 安裝指南
- 安装指南
- Panduan Instalasi
- מדריך התקנה
Dell PowerConnect W-3000 Series Controller | Installation Guide Installing the W-3000 Series Controllers | 13
Chapter 2
Installing the W-3000 Series
Controllers
The following tools and equipment are required for installing the Dell PowerConnect W-3000 Series Controllers:
z Rack Mount Bracket (x2, not used for tabletop installation)
z Suitable Screwdrivers
z AC Power Cord (country-specific)
For a Telecom Rack:
z 6-32 x 1/4” Phillips Head Screws (6x, included)
z 12-24 x 5/8” Phillips Head Screws (4x, included)
For a Server Rack:
z 6-32 x 1/4” Phillips Head Screws (6x, included)
z M6 x 20mm Phillips Head Screws (4x, included)
z M6 Cage Nuts (4x, inluded) or M6 Cage Clips (4x, inluded)
Installation in a Telecom Rack
To install the W-3000 Series Controllers into a 19-inch (48.26 cm) rack system:
1. Place a rack mount bracket over the mounting holes on one side of the controller (see Figure 1).
2. Secure the bracket to the controller using three 6-32 x 1/4” phillips flat head screws and a suitable screwdriver.
3. Repeat these steps on the opposite side of the controller.
Warning: Before performing the following procedure, review the safety instructions that came with the controller.