Users Guide
Table Of Contents
- Installation Guide
- Installationsanleitung
- Inhalt
- Zu diesem Handbuch
- PowerConnect W-3000 Serie Controller
- Installieren des W-3000 Serie Controller
- Technische Daten, Sicherheit und Konformität
- Guide d’installation
- Table des matières
- À propos de ce guide
- À propos des contrôleurs Dell PowerConnect Série W-3000
- Installation du contrôleur Série W-3000
- Spécifications, sécurité et conformité
- Guía de instalación
- Contenido
- Acerca de esta guía
- Acerca de los controladores PowerConnect Serie W-3000
- Instalación de los controladores Serie W-3000
- Especificaciones, seguridad y cumplimiento
- Guia de instalação
- Índice
- Sobre este guia
- Sobre os Controladores Série W-3000 PowerConnect
- Instalação dos Controladores Série W-3000
- Especificações, segurança e conformidade
- Kurulum Kılavuzu
- İçindekiler
- Bu Kılavuz Hakkında
- PowerConnect W-3000 Serisi Denetleyiciler Hakkında
- W-3000 Serisi Denetleyiciler Kurulumu
- Spesifikasyonlar, Güvenlik ve Uygunluk
- 設置ガイド
- 설치 안내서
- 安裝指南
- 安装指南
- Panduan Instalasi
- מדריך התקנה
Dell PowerConnect W-3000 Series Controller | Installation Guide Installing the W-3000 Series Controllers | 15
Figure 3 Air Flow Requirements
7. Connect the AC power cord (country-specific) to the rear of the unit.
8. Plug the opposite end of the power cord into an electrical outlet to power on the controller.
Installation in a Server Rack
To install a W-3000 Series Controllers controller into a 19-inch (48.26 cm) Server rack system:
1. Place a rack mount bracket over the mounting holes on one side of the controller (see Figure 1).
2. Secure the bracket to the controller using three 6-32 x 1/4” phillips head screws and a suitable screwdriver.
3. Repeat these steps on the opposite side of the controller.
4. Install the four cage nuts.
a. Begin by inserting the lower lip of the cage but over the square opeing in the back of the rail.
b. Insert the small end of the cage-nut installation tool through the opening in the rail (from the front), and
hook the tool over the top lip of the cage nut.
c. Push the cage nut in towards the rail while rotating the tool up and pulling the tool back toward you until
the top lip of the cage nut snaps into position.
5. Mount the controller within your organization’s rack system using four M6 x 20mm phillips head screws and
suitable screwdriver.
6. Leave a minimum of four inches (10cm) of space on the left and right side of the unit for proper air flow and
ventilation (see Figure 3).
7. Leave additional space in front and back of the unit to access power cords, network cables, and LED status
indicators (see Figure 3).
8. Connect the AC power cord (country-specific) to the rear of the unit.
9. Plug the opposite end of the power cord into an electrical outlet to power the controller.
Keep Clear for
Air Exhaust
Keep Clear for Air Intake
Keep Open for
Easy Access
Keep Open for
Easy Access
4 inches (10
cm) Minimum
Note: The following instructions describe the installation of your controller in a rack with unthreaded, square holes. For a rack
with unthreaded, round holes, use the provided clip nuts instead.
Note: W-3000 Series Controllers do not have a power on/off switch. Power to the unit is controlled by inserting (or unplugging) the
power cord plug into your electric outlet.