Users Guide
Table Of Contents
- Installation Guide
- Installationsanleitung
- Inhalt
- Zu diesem Handbuch
- PowerConnect W-3000 Serie Controller
- Installieren des W-3000 Serie Controller
- Technische Daten, Sicherheit und Konformität
- Guide d’installation
- Table des matières
- À propos de ce guide
- À propos des contrôleurs Dell PowerConnect Série W-3000
- Installation du contrôleur Série W-3000
- Spécifications, sécurité et conformité
- Guía de instalación
- Contenido
- Acerca de esta guía
- Acerca de los controladores PowerConnect Serie W-3000
- Instalación de los controladores Serie W-3000
- Especificaciones, seguridad y cumplimiento
- Guia de instalação
- Índice
- Sobre este guia
- Sobre os Controladores Série W-3000 PowerConnect
- Instalação dos Controladores Série W-3000
- Especificações, segurança e conformidade
- Kurulum Kılavuzu
- İçindekiler
- Bu Kılavuz Hakkında
- PowerConnect W-3000 Serisi Denetleyiciler Hakkında
- W-3000 Serisi Denetleyiciler Kurulumu
- Spesifikasyonlar, Güvenlik ve Uygunluk
- 設置ガイド
- 설치 안내서
- 安裝指南
- 安装指南
- Panduan Instalasi
- מדריך התקנה
![](/manual/dell/w-3200/users-guide-german/images/img-15.png)
16 | Installing the W-3000 Series Controllers Dell PowerConnect W-3000 Series Controller | Installation Guide
Tabletop Deployment
To deploy an W-3000 Series Controllers on a flat surface, such as a tabletop:
1. Insert the four rubber mounting feet to the bottom of the unit.
2. Attach side bezels by snapping them into place.
3. Place the unit on a hard flat surface.
Initial Setup and Network Connectivity
Once the physical installation is complete, run the initial setup on the controller to configure the IP address and
other basic system information. For complete details and instructions, refer to the ArubaOS Quick Start Guide for
the software version installed on your controller.
Removal
To remove the W-3000 Series Controllers from a 19-inch (48.26 cm) rack system:
1. Disconnect the power to the controller by unplugging the power cord from the electrical outlet.
2. Disconnect any other cables or devices attached to the controller.
3. Loosen the four rack mount screws securing the controller to your organizations rack system.
4. Remove the controller from the rack system.