Reference Guide

10 |Introduction Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
Commands That Reset the Controller or AP
If you use the CLI to modify a currently provisioned and running radio profile, those changes take place
immediately; you do not reboot the controller or the AP for the changes to affect the current running
configuration. Certain commands, however, automatically force the controller or AP to reboot. You may want to
consider current network loads and conditions before issuing these commands, as they may cause a momentary
disruption in service as the unit resets. Note also that changing the lms-ip parameter the in an AP system profile
associated with an AP group will cause all APs in that AP group to reboot.
Command Line Editing
The system records your most recently entered commands. You can review the history of your actions, or reissue a
recent command easily, without having to retype it.
To view items in the command history, use the up arrow to move back through the list and the down arrow key to
forward. To reissue a specific command, press Enter when the command appears in the command history. You
can even use the command line editing feature to make changes to the command prior to entering it.
Commands that reset an AP
z ap-regroup
z ap-rename
z apboot
z apflash
z provision-ap reprovision
z ap wired-ap-profile <profile> forward-
mode {bridge|split-tunnel|tunnel}
z wlan virtual-ap <profile> {aaa-profile
<profile>|forward-mode
{tunnel|bridge|split-tunnel|decrypt-
tunnel}|ssid-profile <profile>|vlan
<vlan>...}
z ap system-profile <profile>
{bootstrap-threshold <number>|lms-
ip <ipaddr>|master-ip <ipaddr>}
z wlan ssid-profile <profile> {battery-
boost|deny-
bcast|essid|opmode|strict-
svp|wepkey1 <key>|wepkey2
<key>|wepkey3 <key>|wepkey4
<key>|weptxkey
<index>|wmm|wmm-be-dscp <best-
effort>|wmm-bk-dscp
<background>|wmm-ts-min-inact-int
<milliseconds>|wmm-vi-dscp
<video>|wmm-vo-dscp
<voice>|wpa-hexkey <psk>|wpa-
passphrase <string>}
z wlan dotllk <profile> {bcn-
measurement-mode|dot11k-
enable|force-dissasoc}
Commands that reset a controller
z reload