Reference Guide

Table Of Contents
Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show rft profile | 1008
show rft profile
show rft profile {all|antenna-connectivity|link-quality|raw}
Description
Show parameters for the predefined RF test profiles.
Syntax
Usage guidelines
The rft command is used for RF troubleshooting, and should only be used under the supervision of Dell technical
support. Issue the show rft profile command to view the profiles used for these RF tests.
Example
The following example shows the testing parameters for the predefined link-quality RF test profile.
Related Commands
To view the results of an RF test, use the command show rft result.
Command History
This command was available in ArubaOS 3.0.
Command Information
Parameter Description
all Show all predefined profiles.
antenna-connectivity Show configured parameters for the predefined Antenna Connectivity test profile.
link-quality Show configured parameters for the predefined Link Quality test profile.
raw Show configured parameters for the predefined RAW test profile.
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config mode on local and master
controllers
(host) #show rft profile link-quality
Profile LinkQuality: Built-in profile
--------------------------------------
Parameter Value
--------- -----
Antenna 1 and/or 2
Frame Type Null Data
Num Packets 100 for each data-rate
Packet Size 1500
Num Retries 0
Data Rate All rates are tried