Reference Guide

1027 | show snmp user-table Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
show snmp user-table
show snmp user-table [user <username> auth-prot [sha | md5] <value> priv-prot [aes |
des] <value>]
Description
Displays the list of SNMP user profile for a specified username.
Syntax
Example
The output of this command shows the list of SNMP traps sent to host.
Command History
This command was available in ArubaOS 3.0
Command Information
Parameter Description
auth-prot Authentication protocol for the user, either HMAC-MD5-98 Digest Authentication Protocol (MD5) or HMAC-
SHA-98 Digest Authentication Protocol (SHA), and the password for use with the
designated protocol.
priv-prot Privacy protocol for the user, either Advanced Encryption Standard (AES) or CBC-DES Symmetric Encryption
Protocol (DES), and the password for use with the designated protocol.
Platforms Licensing Command Mode
All platforms Base operating system Config or Enable mode on master or local
controllers
(host) # show snmp user-table
SNMP USER TABLE
---------------
USER AUTHPROTOCOL PRIVACYPROTOCOL FLAGS
---- ------------ --------------- -----
Sam SHA AES
fire SHA AES