Reference Guide

Table Of Contents
Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide ap provisioning-profile | 103
Syntax
Usage Guidelines
The AP provisioning profile allows you to define a set of provisioning parameters to an AP group. These settings
Parameter Description Range Default
clone <source> Clone an existing ap provisioning profile
domain-name Domain name for the AP or AP group.
link-priority-
cellular <link-
priority-cellular>
Set the priority of the cellular uplink. By default, the cellular
uplink is a lower priority than the wired uplink; making the
wired link the primary link and the cellular link the
secondary or backup link.
Configuring the cellular link with a higher priority than your
wired link priority will set your cellular link as the primary
controller link.
0-255 0
link-priority-
ethernet <link-
priority-ethernet>
Set the priority of the wired uplink. Each uplink type has an
associated priority; wired ports having the highest priority
by default.
0-255 0
master Change the FQDN or IP address for the master controller.
set <masterstr> Specify the or IP address or FQDN for the master controller.
clear Clear the definition for the master controller in this profile.
no Negates any configured parameter.
pppoe-passwd Point-to-Point Protocol over Ethernet (PPPoE) password for
the AP.
——
pppoe-service-
name
PPPoE service name for the AP.
pppoe-user PPPoE username for the AP.
remote-ap Specifies that the profile is to be associated with a remote
AP using certificates.
——
reprovision Provisions one or more APs with the values in the
provisioning profile.
——
reset-bootinfo Restores factory default provisioning parameters to the
specified AP.
NOTE: This parameter can only be used on the master
controller.
——
usb-dev The USB device identifier.
usb-dial The dial string for the USB modem. This parameter only
needs to be specified if the default string is not correct.
usb-init The initialization string for the USB modem. This parameter
only needs to be specified if the default string is not correct.
usb-passwd A PPP password, if provided by the cellular service provider
usb-tty The TTY device path for the USB modem. This parameter
only needs to be specified if the default path is not correct.
usb-type The USB driver type.
usb-user The PPP username provided by the cellular service
provider