Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show usb | 1048
show usb
crypto-local
show usb [cellular|ports|test|verbose]
Description
Display detailed USB device information.
Syntax
Examples
The USB Device table, in the example below, displays the USB port is in the 'Device Ready' state, meaning that
the port has passed the diagnostic test and is ready to send and receive data.
Below is an example of the show usb verbose display output (partial).
Command History
Introduced in ArubaOS 3.4.
Command Information
Parameter Description
cellular Enter the keyword cellular to display cellular devices.
ports Enter the keyword ports to display detailed TTY port information such as signal
strength.
test Enter the keyword test to test the USB TTY ports.
NOTE: Testing an invalid modem port may cause the controller to “hang”. To resolve
this, unplug and re-plug the modem.
verbose Enter the keyword verbose to display detailed USB information including serial
number and USB type.
Platforms Licensing Command Mode
Aruba 600 controllers Base operating system Config mode on master and local controllers
(host) (config-cellular new_modem)# show usb
USB Device Table
----------------
Address Product Vendor ProdID Serial Type Profile State
------- ------- ------ ------ ------ ---- ------- -----
18 Novatel Wireless CDMA 1410 4100 091087843891000 Cellular new_modem Device ready
(host) #show usb verbose
...
T: Bus=01 Lev=02 Prnt=02 Port=00 Cnt=01 Dev#= 3 Spd=12 MxCh= 0
D: Ver= 1.10 Cls=00(>ifc ) Sub=00 Prot=00 MxPS=64 #Cfgs= 1
P: Vendor=1410 ProdID=4100 Rev= 0.00
S: Manufacturer=Novatel Wireless Inc.
S: Product=Novatel Wireless CDMA
S: SerialNumber=091087843891000
C:* #Ifs= 5 Cfg#= 1 Atr=a0 MxPwr=500mA
...