Reference Guide

1098 | show wlan dot11k-profile Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Measurement Mode for Beacon
Reports
Shows the profile’s beacon measurement mode:
z active : In this mode, the client sends a probe request to the broadcast destination
address on all supported channels, sets a measurement duration timer, and, at the end
of the measurement duration, compiles all received beacons or probe response with
the requested SSID and BSSID into a measurement report.
z beacon-table: In this mode, the client measures beacons and returns a report with
stored beacon information for any supported channel with the requested SSID and
BSSID. The client does not perform any additional measurements. This is the default
beacon measurement mode.
z passive: In this mode, the client sets a measurement duration timer, and, at the end of
the measurement duration, compiles all received beacons or probe response with the
requested SSID and BSSID into a measurement report.
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config mode on master or local controllers.
Parameter Description