Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show wms monitor-summary | 1125
show wms monitor-summary
show wms channel stats
Description
Display the numbers of different AP and client types monitored over the last 5 minutes, 1 hour, and since the
controller was last reset.
Syntax
No parameters.
Usage Guidelines
The WLAN management system (WMS) on the controller monitors wireless traffic to detect any new AP or
wireless client station that tries to connect to the network. When an AP or wireless client is detected, it is
classified and its classification is used to determine the security policies which should be enforced on the AP or
client. Use the show wms monitor-summary command to view a quick summary of each classified AP and client
type currently on the network.
If AP learning is enabled (with the wms general command), non-Dell APs connected on the same wired network
as Dell APs are classified as valid APs. If AP learning is disabled, a non-Dell AP is classified as an unsecure or
suspect-unsecure AP.
Example
This example shows that the controller currently has 144 valid APs and 32 active valid clients, and verifies that
the controller currently aware of a single disabled rogue AP.
Command History
This command was introduced in ArubaOS 3.0
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers
(host) #show wms monitor-summary
WMS Monitor Summary
-------------------
Last 5 Min Last Hour All
- ---------- --------- ---
Valid APs 0 0 144
Interfering APs 0 0 0
Rogue APs 0 0 0
Disabled Rogue APs 0 0 1
Unclassified APs 0 0 0
Known Interfering APs 0 0 0
Suspected Rogue APs 0 0 0
Valid Clients 0 0 32
Interfering Clients 0 0 0
Disabled Rogue Clients 0 0 0