Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide wlan voip-cac-profile | 1222
wlan voip-cac-profile
wlan voip-cac-profile <profile>
bandwidth-cac
bandwidth-capacity <bandwidth-capacity>
call-admission-control
call-capacity
call-handoff-reservation <percent>
clone <profile>
disconnect-extra-call
no ...
send-sip-100-trying
send-sip-status-code client|server <code>
wmm_tspec_enforcement
wmm_tspec_enforcement_period <seconds>
Description
This command configures a voice over iP (VoIP) call admission control (CAC) profile.
Syntax
Parameter Description Range Default
<profile> Name of this instance of the profile. The name must be 1-63
characters.
— “default”
bandwidth-cac Select the desired call admission control (CAC)
Mechanism:
z Disable - CAC is based on Call Counts
z Enable - CAC should be based on Bandwidth.
— disabled
bandwidth-capacity Define the maximum bandwidth that can be handled by one
radio, in kbps. The default value is 2000 kbps (2 Mbps)
——
<bandwidth-capacity> Maximum bandwidth that can be handled by one radio, in
kbps. The default value is 2000 kbps (2 Mbps)
1-600000 2000
call-admission-
control
Enables or disables WiFi VoIP Call Admission Control
features.
— disabled
call-capacity Number of simultaneous calls that can be handled by one
radio.
0-8000 10
call-handoff-
reservation
Percentage of call capacity reserved for mobile VoIP
clients on call.
0-100 20%
clone Name of an existing VoIP CAC profile from which parameter
values are copied.
——
disconnect-ex
tra-call
Disconnects calls that exceed the high capacity threshold
by sending a deauthentication frame.
— disabled
no Negates any configured parameter. — —
send-sip-100-
trying
Enables sending of SIP 100 - trying messages to a call
originator to indicate that the call is proceeding. This is
useful when the SIP invite may be redirected through a
number of servers before reaching the controller.
— enabled