Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide cp-bandwidth-contract | 157
cp-bandwidth-contract
cp-bandwidth-contract <name> {mbits <1..2000>}|{kbits <256..2000000>}
Description
This command configures a bandwidth contract traffic rate which can then be associated with a whitelist session
ACL.
Syntax
Example
The following example configures a bandwidth contract named “cp-rate” with a rate of 10,000Kbps.
(host)(config) #cp-bandwidth-contract cp-rate kbits 10000
Related Commands
Command History
This command was introduced in ArubaOS 3.4
Command Information
Parameter Description
<name> Name of a bandwidth contract.
mbits <1..2000> Set a bandwidth rate inn mbits/seconds.
kbits <256..2000000> Set a bandwidth rate in kbits/seconds.
Command Description Mode
show cp-bwcontracts Display a list of Control Processor (CP) bandwidth
contracts for whitelist ACLs.
Enable or Config modes
firewall cp This command creates a new whitelist ACL and can
associate a bandwidth contract with that ACL.
Enable or Config modes
Platforms Licensing Command Mode
All platforms This command requires the PEFNG
license.
Config mode on master controllers