Reference Guide

Table Of Contents
183 | enable secret Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
enable secret
enable secret
Description
This config mode command allows you to change the password for enable mode.
Usage Guidelines
Use this command to change the password for enable mode. To reset the password to the factory default of
“enable”, use the no enable command.
Example
The following example allows you to change the password for enable mode.
(host) #configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(host) (config) #enable secret
Password:******
Re-Type password: ******
(host) (config) #
Command History
Command Information
Note: The password must not contain the space and ‘?’ special characters.
Version Modification
ArubaOS1.0 Command introduced
ArubaOS 3.3.2 Updated with restriction of the secret phase
Platform License Command Mode
Available on all platforms Available in the base operating system Config mode on master or local
controllers