Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide firewall cp-bandwidth-contract | 203
firewall cp-bandwidth-contract
firewall cp-bandwidth-contract {auth|route|sessmirr|trusted-mcast|trusted-ucast
|untrusted-mcast|untrusted-ucast} <Rate>
Description
This command configures bandwidth contract traffic rate limits to prevent denial of service attacks.
Syntax
Usage Guidelines
This command configures firewall bandwidth contract options on the controller.
Example
The following command disallows forwarding of non-IP frames between users:
(host) (config) #firewall deny-inter-user-bridging
Related Commands
(host) (config) #show firewall
Command History
Introduced in ArubaOS 3.4
Command Information
Parameter Description Range Default
auth Specifies the traffic rate limit that is forwarded to the
authentication process.
1-200 Mbps 1
route Specifies the traffic rate limit that needs ARP requests. 1-200 Mbps 1
sessmirr Specifies the session mirrored traffic forwarded to the controller. 1-200 Mbps 1
trusted-mcast Specifies the trusted multicast traffic rate limit. 1-200 Mbps 2
trusted-ucast Specifies the trusted unicast traffic rate limit. 1-200 Mbps 80
untrusted-mcast Specifies the untrusted multicast traffic rate limit. 1-200 Mbps 2
untrusted-ucast Specifies the untrusted unicast traffic rate limit. 1-200 Mbps 10
Platform License Command Mode
Available on all platforms This command requires the PEFNG license Config mode on master
controllers