Reference Guide

Table Of Contents
Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide ntp server | 348
ntp server
ntp server <ipaddr> [iburst]
Description
This command configures a Network Time Protocol (NTP) server.
Syntax
Usage Guidelines
You can configure the controller to set its system clock using NTP by specifying one or more NTP servers.
Example
The following command configures an NTP server:
(host) (config) #ntp server 10.1.1.245
Command History
Command Information
Parameter Description Default
<ipaddr> IP address of the NTP server, in dotted-decimal format.
iburst (Optional) This parameter causes the controller to send up to ten queries
within the first minute to the NTP server. This option is considered
“aggressive” by some public NTP servers.
disabled
Release Modification
ArubaOS 1.0 Command introduced
ArubaOS 3.0 The iburst parameter was introduced
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers