Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide provision-ap | 373
g-ant-tilt-angle Directs the angle of the 802.11g (2.4GHz) antenna for
optimum coverage.
Use a - (negative) value for downtilt and a + (positive) value
for uptilt.
NOTE: This parameter is supported on outdoor APs only. If
you use this parameter to configure an indoor AP, an error
message is displayed.
-90 to +90
Decimal Degrees
—
g-antenna Antenna use for 2.4 GHz (802.11g) frequency band.
z 1: Use antenna 1
z 2: Use antenna 2
z both: Use both antennas
1, 2, both both
gateway IP address of the default gateway for the AP. — —
ikepsk IKE preshared key for the AP. — —
installation Specify the type of installation (indoor or outdoor). The
default parameter automatically selects an installation
mode based upon the AP model type.
default
indoor
outdoor
default
ipaddr Static IP address for the AP. — —
latitude Latitude coordinates of the AP. Use the format: Degrees,
Minutes, Seconds (DMS). For example: 37 22 00 N
——
longitude Longitude coordinates of the AP. Use the DMS format. For
example: 122 02 00 W
——
master Name or IP address of the master controller. — —
mesh-role Configure the AP to operate as a mesh node. You assign
one of three roles: mesh portal, mesh point or remote mesh
point. If you select “none,” the AP operates as a thin AP.
mesh-portal
mesh-point
remote-mesh-
portal
none
—
mesh-sae Enable or disable Secure Attribute Exchange (SAE) on a
mesh network. To use the SAE feature, you must enable this
parameter on all mesh nodes (points and portals) in the
network, to prevents mesh link connectivity issues.
NOTE: This is a Beta feature only. This parameter should be
kept “disabled” for this release.
sae-disable
sae-enable
sae-disable
netmask Netmask for the IP address. — —
no Negates any configured parameter. — —
pap-passwd Password Authentication Protocol (PAP) password for the
AP.
You can use special characters in the PAP password.
Following are the restrictions:
z You cannot use double-byte characters
z You cannot use a tilde (~)
z You cannot use a tick (‘)
z If you use quotes (single or double), you must use the
backslash (\) before and after the password
——
pap-user PAP username for the AP. — —
pppoe-passwd Point-to-Point Protocol over Ethernet (PPPoE) password for
the AP.
——
pppoe-service-
name
PPPoE service name for the AP. — —
Parameter Description Range Default