Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide rf dot11g-radio-profile | 408
Usage Guidelines
This command configures radios that operate in the 2.4 GHz frequency band, which includes radios utilizing the
IEEE 802.11b/g or IEEE 802.11n standard. Channels must be valid for the country configured in the AP
regulatory domain profile (see “ap regulatory-domain-profile” on page 108).
To view the supported channels, use the show ap allowed-channels command.
Examples
The following command configures APs to operate in AM mode for the selected dot11g-radio-profile named
“sampleg:”
rf dot11g-radio-profile sampleg
mode am-mode
The following command configures APs to operate in high-throughput (802.11n) mode on the
2.4 Ghz frequency band for the selected dot11g-radio profile named “sampleg” and assigns a high-throughout
radio profile named “default-g:”
rf dot11g-radio-profile sampleg
high-throughput-enable
ht-radio-profile default-g
The following command configures a primary channel number of 1 and a secondary channel number of 5 for 40
MHz mode of operation for the selected dot11g-radio profile named “sampleg:”
rf dot11g-radio-profile sampleg
channel <1+>
Command History
Command Information
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.3.2 Introduced protection for 802.11b clients and support for the high-throughput IEEE 802.11n
standard.
ArubaOS 3.4 Support for the following parameters:
z Spectrum load balancing
z Spectrum load balancing domain
z RX Sensitivity Tuning Based Channel Reuse
z RX Sensitivity Threshold
z ARM/WIDS Override
ArubaOS 3.4.1 The maximum-distance parameter was introduced.
ArubaOS 3.4.2 The beacon-regulate parameter was introduced.
ArubaOS 6.0 Configure an Air Monitor (AM) scanning profile (am-scan-profile)
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers