Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide Introduction | 5
Modified Commands
The following commands were modified in ArubaOS 6.0.
voice sip This command allows you to enable SIP session timer and associate a dial plan profile to the
SIP ALG.
Command Parameter Description
aaa authentication
captive-portal
<profile>max-
authentication-failures
<number>
The max-authentication-failures parameter no longer requires a license.
aaa authentication-server
radius host
<ipaddr>|<FQDN>
Identify the RADIUS server either by its IP address or fully qualified domain name.
aaa authentication-server
tacacs
Enables TACACS+ authorization.Session-authorization turns on the optional
authorization session for admin users.
ap system-profile
am-scan-rf-band [a | g |
all]
Added option for scanning band for multiple RF radios
clear aaa tacacs—to clear TACACS server statistics.
interface vlan The pppoe-max-segment-site, pppoe-password, pppoe-service-name and pppoe-
password parameters were introduced.
ip mobile domain A new parameter, description is added for providing more information about a HAT
entry.
netservice The list parameter for defining non-contiguous ports was introduced.
rf dot11a-radio-profile
am-scan-profile <profile-
name>
Configure an Air Monitor (AM) scanning profile.
rf dot11g-radio-profile
am-scan-profile <profile-
name>
Configure an Air Monitor (AM) scanning profile.sss
shape-mcast Enables multicast optimization and provides excellent streaming quality regardless
of the amount of VLANs or IP IGMP groups that are used.
show aaa authentication-
server tacacs
The Statistics parameter was introduced.
show ap debug system-
status
Show crash information for an AP with a specified name.
show ip mobile Description of the HAT entry.
show spanning-tree Added PVST+ in the display output
show spantree Added PVST+ in the display output
show switches The version column in the output of this command was expanded to include both
the version and the build number for controllers running ArubaOS 6.0 and later
releases.
show voice call-cdrs The cid and rtpa parameters were introduced.
show voice call-quality The rtpa and sta parameters were introduced.
Command Description