Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show ap active | 514
show ap active
show ap active [ap-name <ap-name>|{arm-edge dot11a|dot11g|voip-
only}|dot11a|dot11g|essid <essid>|ip-addr <ip-addr>|{type access-point|air-
monitor|(sensor dot11a|dot11g|voip-only)}|voip-only
Description
Show all active APs registered to a controller.
Syntax
Usage Guidelines
This command displays details for all active APs on the controller. If an AP on your network does not appear in
this table, it may have been classified as an inactive AP for any of the following reasons:
z The AP is configured with a missing or incorrect VLAN. (For example, the AP is configured to use a tunneled
SSID of VLAN 2 but the controller doesn't have a VLAN 2.)
z The AP has an unknown AP group.
z The AP has a duplicate AP name.
z An AP with an external antenna is not provisioned with external antenna gain settings.
z Both radios on the AP are disabled.
z No virtual APs are defined on the AP.
z The AP has profile errors. Issue the command `show profile errors” for details.
z The GRE tunnel between the AP and the controller was blocked by a firewall after the AP became active.
z The AP is temporarily down while it is upgrading its software. The AP will become active again after
upgrading.
Parameter Description
ap-name <ap-name> View data for an AP with a specified name.
arm-edge Show the state of ARM edge APs.
dot11a Show 802.11a radio information.
dot11g Show 802.11g radio information.
voip-only Show AP information filtered by associated/active VoIP clients.
essid <essid> View data for a specific ESSID (Extended Service Set Identifier). An
Extended Service Set Identifier (ESSID) is a alphanumeric name that
uniquely identifies a wireless network. If the name includes spaces, you
must enclose the ESSID in quotation marks.
ip-addr <ip-addr> View data for an AP with a specified IP address by entering an IP address in
dotted-decimal format.
type Show AP information filtered by type of AP.
access-point Show information for Access Points only.
air-monitor Show information for Air Monitors only.
sensor Show only RFprotect Sensor information.
voip-only Show AP information filtered by associated/active VoIP clients.