Manualshelf

Reference Guide

ManualsBrandsDell ManualsTVs & monitorsW-620
521522523524525526527528529530
Table Of Contents
515 |show ap active Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
z An AP has conflicting configuration settings. For example, if the AP system profile on a single radio dual-
band AP configures the radio uses 802.11g, but the virtual AP profile on the AP is set to use 802.11a, the AP
might not appear to be active.
z A remote AP model 5WN or 2WG attempted to connect to a controller without using IPSec.
Example
The output of the command in the example below shows that the controller sees six active APs.
The output of this command includes the following information:
(host)# show ap active
Active AP Table
---------------
Name Group IP Address 11g 11g Ch/EIRP/MaxEIRP 11a 11a Ch/EIRP/MaxEIRP AP
Type Flags Uptime
Clients Clients
---- ----- ---------- ----- ------------------- ------ ---------------- ---
---- ----- ------
AL31 corp1344 10.6.1.202 0 AP:HT:1/8.5/33 0 AP:HT:149+/19/36 125
Column Description
Name Name of an AP
Group The AP is associated with this AP group.
IP address IP address of the AP, in dotted decimal format.
11g Clients Number of 802.11g clients using the AP.
11g Ch/EIRP/MaxEIRP 802.11g radio channel used by the AP/current effective Isotropic Radiated Power (EIRP) /
maximum EIRP.
11a Clients Number of 802.11a clients using the AP.
11a Ch/EIRP/MaxEIRP 802.11a radio channel used by the AP/current EIRP/maximum EIRP.
AP Type AP model type.
Flags This column displays any flags for this AP. The list of flag abbreviations is also included in the
output of the show ap active command.
z a = Reduce ARP packets in the air
z A = Enet1 in active/standby mode
z B = Battery Boost On
z d = Drop Mcast/Bcast On or Disconnected Sensor
z D = Disconn. Extra Calls On
z E = Wired AP enabled
z K = 802.11K Enabled
z L = Client Balancing Enabled
z M = Mesh
z N = 802.11b protection disabled
z P = PPPOE
z R = Remote AP
z R- = The remote AP requires captive portal authentication. Once this authentication is
successfully completed, the R- flag changes to R.
z S = RFprotect Sensor
z U = USB modem
z X = Maintenance Mode