Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show ap arm scan-times | 526
The output of this command includes the following parameters:
Command History
Introduced in ArubaOS 3.0.
Command Information
Parameter Description
channel A radio channel on the specified AP.
Assign-time The amount of time that an AP has been on a channel.
scans-attempted The number of times an AP has attempted to scan another channel
scans-rejected The number of times an AP attempted to scan a channel, but was unable to scan because the
scan was halted by the power save, voice aware or load aware ARM features.
dos-scans The number of times an AP enabled with the rogue aware scanning feature had to contain a
rogue device on a channel.
flags The flags column displays additional relevant information about the channel. The flags key
appears at the bottom of the Channel Scan Time table.
timer tick Timer tick at which the last scan was attempted.
last-scan-channel The last channel scanned by the AP
current-scan-channel The AP’s current channel.
last-dos-channel The last channel that had to be contained because a rogue device was detected on that
channel.
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master controllers