Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show ap client status | 542
show ap client status
show ap client status <client-mac>
Description
Show the current status of a specific client.
Syntax
Examples
The output of the command shows the status of an individual client in the STA (station) table.
The output of this command includes the following information:
Parameter Description
<client-mac> MAC address of a client
Column Description
bssid Basic Service Set ID (BSSID) of the client.
auth This column displays a y if the AP has been configured for 802.11 authorization frame types.
Otherwise, it displays an n.
assoc This column displays a y if the AP has been configured for 802.11 association frame types.
Otherwise, it displays an n.
aid Number of beacons in the 802.11 listen interval. There are ten beacons sent per second, so a
ten-beacon listen interval indicates a listen interval time of 1 second.
l-int Number of beacons in the 802.11 listen interval. There are ten beacons sent per second, so a
ten-beacon listen interval indicates a listen interval time of 1 second.
essid Extended Service Set ID (ESSID) of the client.
vlan-id VLAN ID of the VLAN used by the client
tunnel-id Identification number for the tunnel
state If the client has been both authorized and associated, this data column will display auth-assoc.
If the client has only been authorized, this data column will display auth.
Reason If the client failed to authenticate, this data column lists the reason code for 802.11
authentication failure
(host) #show ap client status 00:13:fd:42:32:38
STA Table
---------
bssid auth assoc aid l-int essid vlan-id tunnel-id
----- ---- ----- --- ----- ----- ------- ---------
00:1a:1e:a3:02:c9 y y 7 10 corp-wpa2 65 0x10c0
State Hash Table
----------------
bssid state reason
----- ----- ------
00:1a:1e:a3:02:c9 auth-assoc 0