Reference Guide

553 | show ap coverage-holes Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
show ap coverage-holes
show ap coverage holes
Description
Show information for APs that have detected coverage holes in the wireless network.
Usage Guidelines
This command will only display coverage hole information if you have enabled coverage hole detection using the
command rf optimization-profile <profile> coverage-hole-detection. The coverage hole detection feature
requires the RF Protect license.
Examples
The output of this command
The output of this command includes the following information:
Command History
Introduced in ArubaOS 2.0.
Command Information
Column Description
Name Name of an AP that detected a coverage hole.
BSSID Basic Service Set Identifier (BSSID) of an AP that detected a coverage hole.
Radio The coverage hole is for this radio PHY type (a or g).
STA MAC address of the station.
RSSI The Receive Signal Strength Indicator (RSSI) value displayed in the output of this command
represents signal strength as a signal to noise ratio. For example, a value of 30 would indicate
that the power of the received signal is 30 dBm above the signal noise threshold.
Platforms Licensing Command Mode
All platforms RF Protect license Enable or Config mode on master controllers
(host) #show ap coverage-holes
Coverage Holes Detected
-----------------------
Name BSSID Radio STA RSSI
---- ----- ----- --- ----
ap12 00:1a:1e:c0:7f:fc a 00:0b:86:c7:49:94 15