Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show ap debug counters | 572
show ap debug counters
show ap debug counters {ap-name <ap-name>|bssid <bssid>|group <group>|ip-addr <ip-
addr>}
Description
Show AP message and reboot/bootstrap counters for an individual AP or AP group.
Syntax
Example
The output of this command can you how many times each AP has rebooted (a hard boot) or bootstrapped (a soft
boot), the number of times configuration changes were sent from the controller, and the number of configuration
changes acknowledged by that AP.
The output of this command includes the following information:
Parameter Description
ap-name <ap-name> Show debug counters for an AP with a specified name.
bssid <bssid> Show debug counters for a specific Basic Service Set Identifier (BSSID). The Basic Service
Set Identifier (BSSID) is usually the AP’s MAC address.
group <group> Show debug counters for an AP group.
ip-addr <ip-addr> Show debug counters for an AP with a specified IP address by entering an IP address in
dotted-decimal format.
Column Description
Name Name of the AP.
Group Name of the AP’s group.
IP Address IP address of the AP.
Configs sent Number of times configuration changes have been sent to the AP.
Configs Acked Number of times that the AP has acknowledged receiving a configuration change.
Bootstraps Number of times the AP restarted. Bootstraps are also known as “soft” restarts.
Reboots Number of times power to the AP cycled off and then on again. Reboots also known as “hard”
restarts.
(host) #show ap debug counters group corp1
AP Counters
-----------
Name Group IP Address Configs Configs AP Boots AP Boots Bootstraps Reboots
Sent Acked Sent Acked
---- ----- ---------- ------ ------- -------- -------- ---------- -------
AL1 corp1 10.6.1.209 1597 1597 0 0 1 0
AL10 corp1 10.6.1.198 165 165 0 0 2 1
AL12 corp1 10.6.1.200 195 195 0 0 1 0
AL15 corp1 10.6.1.197 1580 1580 0 0 1 0
AL16 corp1 10.6.1.199 73 73 0 0 1 0
AL19 corp1 10.6.1.212 8 8 0 0 1 0
Total APs :6